Product #1008
From: PAR Enterprises 4333 East Sam Houston Parkway
North, Houston, Texas 77015, 888-222-2225
Please read
container carefully before use. Contents are safe when used
as directed. Cans should be handled properly to avoid accidental
rupture.
At each workstation a holder should be fabricated to secure.
This will prevent cans from falling to the floor from accidental
knocking or machine vibration. A 3 Inch hole cut in a 2 X
4 and nailed to a base makes an excellent holder.
Below are some directions which may help you in using the product
most effectively:
• Shake can moderately before use.
• Spray surface at a distance of approximately 10 to 12 inches.
• Short, quick sprays are sufficient, do not over apply.
• It is not necessary to shield motors or belts from
spray.
• Work area should be resprayed as needed.
• Store cans in a cool, dry place.
Caution: Clean "RF" glue machine thoroughly including scratches.
Clean the area to be treated as much as possible before applying
“WOOD-GLIDE.” If machine is to be used continuously, reapply
as needed.
"WOOD-GLIDE" should be used on all machines that cut, shape,
and route wood, including resin coated blades.
Spray on resin coated blades to remove resin quickly, and
reapply as needed to keep resin from sticking to all blades
and table tops on manual and power-fed equipment.
Caution: Thoroughly clean all aids such as paste wax, carnuba
wax, or paraffins from equipment prior to using "WOOD-GLIDE"
- FAILURE TO DO SO MIGHT RESULT IN
A NON-HARMFUL GUMMY RESIDUE. |
